LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Ignition System (Service Information)) >> Cylinder - Ignition Key/Lock >> Installation

Cylinder - Ignition Key/Lock: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Key Lock Cylinder Removal/Installation
GC0029104Courtesy of DAIMLERCHRYSLER CORP.
  1. Install ignition key into lock cylinder (1). Rotate key to "ON" position (retaining tab on side of lock cylinder (3) can now be depressed).
  2. The shaft at end of key lock cylinder aligns with socket within end of housing. To align socket with lock cylinder, ensure socket is in "ON" position.
  3. Position and align key lock cylinder with grooves in housing.
    Fig 2: Key Cylinder Release Tab
    GC0029103Courtesy of DAIMLERCHRYSLER CORP.
  4. Slide lock cylinder into housing until release tab (3) sticks through opening at side of housing.
    Fig 3: Ignition Switch Bezel
    GC0029102Courtesy of DAIMLERCHRYSLER CORP.
  5. Install bezel (1). Snaps on.
  6. Connect negative battery cable.
scientia non olet · About LEMON Manuals