LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Battery System - Service Information) >> Battery Tray >> Removal

Battery Tray: Removal

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Battery Wire Harness
GC0029013Courtesy of CHRYSLER LLC
  1. Remove the battery from the battery tray. See REMOVAL .
  2. Remove the battery wire harness three pin connector (11) from the battery tray (12).
    Fig 2: Removing/Installing Battery Tray
    GC0029019Courtesy of CHRYSLER LLC
  3. Remove the two screws (3) that secures the battery tray (4) to the inner fender and the bracket on the radiator support.
  4. Remove the one screw (2) that secures the outboard side of the battery tray (4) to the left inner fender.
  5. Remove the one nut (1) that secures the rear of the battery tray to the stud (5) on the front frame rail.
  6. Remove the battery tray from the left front corner of the engine compartment.
scientia non olet · About LEMON Manuals