LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Pump-Water >> Installation >> 3.0L Diesel

3.0L Diesel

Fig 1: 3.0L WATER PUMP
GC0044889Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean all sealing surfaces.
  2. Position and install water pump. Tighten M6 bolts to 14 N.m (124 lbs. in.) and M8 bolts to 20 N.m (177 lbs. in.).
  3. Install idler pulley. Tighten bolt to 35 N.m (26 lbs. ft.).
  4. Install coolant hoses.
  5. Install accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
  6. Close coolant drain.
  7. Install engine cover:
  8. Connect negative battery cable.
  9. Fill coolant system to proper level with the appropriate coolant mixture. Refer to appropriate procedure under STANDARD PROCEDURE .
    WARNING: Use extreme caution when engine is operating. Do not put your hands near pulleys, belts or fan. Do not wear loose clothes.
  10. Start engine and inspect for leaks.
scientia non olet · About LEMON Manuals