Section 66 (Charging System): Generator: Installation: 5.7L

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Generator - 5.7L

Courtesy of DAIMLERCHRYSLER CORP.

Position generator (2) to engine and install 2 mounting bolts (1).
Torque bolts to 41 N.m (30 ft. lbs.)
Snap field wire connector (3) into rear of generator.
Install B+ terminal eyelet to generator output stud. Tighten mounting nut. Refer to TORQUE .
CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment.
Install generator drive belt. Refer to COOLING for procedure.
Install negative battery cable to battery.