LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Wiper System & Washer System (Service Information)) >> Right Multi-Function Switch >> Removal

Right Multi-Function Switch: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
Fig 1: Right Multi-Function Switch
GC0029506Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove both the upper and lower shrouds from the steering column. (Refer to STEERING/COLUMN/SHROUD - REMOVAL) .
  3. Remove the two screws (1) that secure the right multi-function switch (3) to the locating tabs (2) on the right side of the Steering Control Module (SCM) (4).
  4. Pull the switch straight away from the back of the SCM far enough to disconnect it from the SCM.
  5. Remove the switch from the SCM.
scientia non olet · About LEMON Manuals