LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Vehicle Theft Security System (Service Information)) >> Intrusion Sensor >> Installation >> Transmitter

Intrusion Sensor: Installation: Transmitter

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Intrusion Sensor Transmitter
GC0040905Courtesy of DAIMLERCHRYSLER CORP.
  1. Carefully pull down the right rear edge of the headliner from the upper liftgate opening far enough to reach between the headliner and the roof panel to position the intrusion sensor transmitter (2) over the locating pins of the mounting bracket (4) on the headliner substrate.
  2. Press the transmitter down until the two latch features (3) of the mounting bracket are fully engaged.
  3. Reconnect the take out of the overhead wire harness (1) to the connector receptacle on the right side of the transmitter housing.
  4. Reinstall the trim onto the right upper D-pillar. (Refer to D-PILLAR TRIM - INSTALLATION) .
  5. Reinstall the trim onto the upper liftgate opening. (Refer to LIFTGATE OPENING UPPER TRIM - INSTALLATION) .
    Fig 2: Remove/Install Bezel
    GC0040904Courtesy of DAIMLERCHRYSLER CORP.
  6. Position the bezel (1) over the transducer housing (2) of the intrusion sensor transmitter and press it straight upward until it snaps into place against the headliner (3). Be certain to take the appropriate precautions not to soil or damage the headliner.
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals