LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Vehicle Theft Security System (Service Information)) >> Intrusion Module >> Removal

Intrusion Module: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Intrusion Module
GC0047371Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the trim from the inside of the right quarter inner panel (2). (Refer to BODY/INTERIOR/QUARTER TRIM PANEL - REMOVAL) .
  3. Disconnect the take out of the body wire harness from the connector receptacle (4) on the rearward side of the intrusion module (1).
  4. Remove the two nuts (5) that secure the module to the studs (3) on the quarter inner panel.
  5. Remove the module from the studs on the quarter inner panel.
scientia non olet · About LEMON Manuals