LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Anti-Lock Brake System (Service Information)) >> Sensor-Front Wheel Speed >> Installation

Sensor-Front Wheel Speed: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Wheel Speed Connector
GC0026853Courtesy of DAIMLERCHRYSLER CORP.
1 - ELECTRICAL CONNECTOR
2 - CLIP
  1. Reconnect the wheel speed sensor wire connector (1).
  2. Reroute and connect the wheel speed sensor wire to the routing clips (2).
    Fig 2: Removing/Installing Wheel Speed Sensor
    GC0026763Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the wheel speed sensor into the hub (3) and the install the mounting bolt (2) and tighten the nut to 12-14 N.m (106-124 in. lbs.).
  4. Check the sensor wire routing (1). Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.
  5. Install the disc brake rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .
  6. Install the caliper adaptor over the rotor.
  7. Install the caliper adaptor bolts and tighten to 90-115 N.m (66-85 ft. lbs.). (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - INSTALLATION) .
  8. Install the tire and wheel assembly.
  9. Remove the support and lower vehicle.
scientia non olet · About LEMON Manuals