LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Electronic Control Modules (Service Information)) >> Service Information >> Standard Procedure >> Standard Procedure - Programming The SKREEM/WCM Using The DRB®

Standard Procedure - Programming The SKREEM/WCM Using The DRB®

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Read all notes and cautions for programming procedures. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)  .
  1. Connect a battery charger to the vehicle.
  2. Connect the DRB®.
    CAUTION: If the ECM/PCM and SKREEM/WCM are replaced at the same time, the ECM/PCM MUST be programmed before the SKREEM/WCM.
  3. Select "THEFT ALARM".
  4. Select "SKIM - SKREEM".
  5. Select "MISC".
  6. Select "SKREEM REPLACED".
  7. Select "ENTER PIN"
  8. Enter the PIN number.
  9. Verify that the information is correct.
  10. If the ECM/PCM and the SKREEM/WCM have been replaced, replace all ignition keys and program them into the new SKREEM/WCM.
scientia non olet · About LEMON Manuals