LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Electronic Control Modules (Service Information)) >> Service Information >> Standard Procedure >> Standard Procedure - Programming The Pcm/ECM Using The STARSCAN®

Standard Procedure - Programming The Pcm/ECM Using The STARSCAN®

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Read all notes and cautions for programming procedures. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)  .
  1. Connect a battery charger to the vehicle.
  2. Connect the StarSCAN®.
  3. Select "ECU View".
  4. Select "WCM Wireless Control Module".
  5. Select "Miscellaneous Functions".
  6. Select "PCM Replaced".
  7. Enter the PIN when prompted.
  8. Press "Next".
  9. Cycle the Key.
  10. Verify the repair.
scientia non olet · About LEMON Manuals