LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Electronic Control Modules (Service Information)) >> Module-Final Drive Control >> Operation >> Inputs/Outputs

Module-Final Drive Control: Operation: Inputs/Outputs

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The following are inputs to the FDCM:

  1. Lateral Accelerometer
  2. Transfer Case Range Select Switch
  3. Transfer Case Mode Sensor Signal
  4. Front DIfferential Temperature Sensor
  5. Rear Differential Temperature Sensor
  6. 3 Direct Battery Feeds
  7. Ignition RUN Sense
  8. Sensor Grounds
  9. Module Grounds
  10. CAN C Bus

The following are outputs of the FDCM:

  1. 5V Sensor Supply
  2. Transfer Case NEUTRAL Lamp
  3. Front Electronic Limited Slip Differential Pressure Solenoid
  4. Rear Electronic Limited Slip Differential Pressure Solenoid
  5. Transfer Case Bi-directional Motor Control (A & B)
  6. Switched B+ Solenoid Supply
  7. Transfer Case Motor Brake Control
scientia non olet · About LEMON Manuals