LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Electronic Control Modules (Service Information)) >> Module-Antilock Brakes >> Removal

Module-Antilock Brakes: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the negative battery cable from the battery.
  2. Install a brake pedal prop rod.
  3. Siphon the master cylinder.
    Fig 1: HCU Lines & Components
    GC0044655Courtesy of DAIMLERCHRYSLER CORP.
  4. Disconnect the HCU electrical connectors (5).
  5. Remove the primary brake line at the master cylinder.
  6. Remove the primary brake line from the HCU (4).
  7. Remove the secondary brake line at the master cylinder.
  8. Remove the secondary brake line at the HCU (4)
  9. Remove the 4 chassis lines (3) at the HCU (4).
    Fig 2: Identifying ABM/HCU Components
    GC0044738Courtesy of DAIMLERCHRYSLER CORP.
  10. Remove the 1 mounting nut and 1 bolt holding the HCU bracket attachment to the vehicle.
  11. Remove the HCU (3) with the bracket (5) from the vehicle.
    Fig 3: Antilock Brake Module & Hydraulic Control Unit
    GC0026855Courtesy of DAIMLERCHRYSLER CORP.
    1 - ABM
    2 - HCU
  12. Remove the 3 ABM bolts securing the ABM (1) to the HCU (2).
    Fig 4: ABM/HCU Separated
    GC0045386Courtesy of DAIMLERCHRYSLER CORP.
  13. Separate the ABM (1) from the HCU (2).
scientia non olet · About LEMON Manuals