Right Multi-Function Switch: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

Fig 1: Right Multi-Function Switch

Courtesy of CHRYSLER LLC

Position the right multi-function switch (3) to the back of the Steering Control Module (SCM) and reconnect the switch connector to the SCM.
Align the two locating tabs (2) on the SCM with the switch housing.
Install and tighten the two screws (1) that secure the switch to the SCM. Tighten the screws to 0.35 N.m (3 in. lbs.).
Reinstall the upper and lower shrouds onto the steering column. Refer to INSTALLATION .
Reconnect the battery negative cable.