Right Fuel Rail
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BREATHER / OIL SEPARATOR |
| 2 - FUEL RAIL PRESSURE SENSOR |
| 3 - FUEL RAIL |
| 4 - VACUUM PUMP |
| 5 - CAMSHAFT POSITION SENSOR |
| 6 - FUEL INJECTORS |
WARNING:
(Refer to FUEL SYSTEM - WARNING) . No sparks, open flames or smoking. Risk of poisoning from inhaling and swallowing fuel. Risk of injury to eyes and skin from contact with fuel. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing.
CAUTION:
Inspect sealing cones at the lines. Replace as necessary. Ensure that all fuel pressure lines are exactly located in original position.
- Carefully position the fuel rail and hand tighten all of the high pressure fuel lines.
- Install the fuel rail fasteners and tighten to 11 N.m (97 in. lbs.).
- Tighten the high pressure line to the fuel rail to 33 N.m (24 ft. lbs.)
- Tighten the high pressure fuel rail transfer pipe to 27 N.m (19 ft. lbs.).
- Tighten the high pressure fuel lines at the fuel rail to 27 N.m (19 ft. lbs.).
- Tighten the high pressure fuel lines at the fuel injectors to 27 N.m (19 ft. lbs.).
- Connect the fuel rail pressure sensor.
- Connect the negative battery cable.
- Start engine, allow to warm, turn engine off and inspect for leaks.
- Install the strut tower support.
- Install engine cover.