LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System >> Relay-Starter Motor >> Removal

Relay-Starter Motor: Removal

The starter relay is located in the Power Distribution Center (PDC). Refer to label on PDC cover for relay location.

  1. Disconnect and isolate negative battery cable.
  2. Remove cover from Power Distribution Center (PDC) for relay identification and location.
  3. Remove starter relay from PDC.
  4. Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.
  5. Check for pin height (pin height should be the same for all terminals within the PDC connector). Repair if necessary before installing relay.
scientia non olet · About LEMON Manuals