LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems (Service Information) >> Controls-Front >> Module-Power-Blower Motor >> Installation

Module-Power-Blower Motor: Installation

Fig 1: Power Module-Blower Motor - Removing/Installing
GC0028312Courtesy of DAIMLERCHRYSLER CORP.
NOTE: LHD model shown. RHD model similar.
  1. Position the blower motor power module (2) into the HVAC housing (4).
  2. Install the two screws (3) that secure the blower motor power module to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the two wire harness connectors (1) to the blower motor power module.
  4. On LHD models, install the glove box into the instrument panel (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - INSTALLATION) .
  5. On RHD models, install the instrument panel silencer onto the passenger side of the instrument panel .
  6. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals