LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (5.7L Engine (Service Information)) >> Intake Manifold >> Installation

Intake Manifold: Installation

WARNING: This page is about a different car, the 2005 Dodge Magnum and 2005 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position intake manifold.
  2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 N.m (105 in. lbs.).
  3. Install EGR tube.
  4. Install wire harness on intake manifold.
  5. Connect electrical connectors for the following components:
    • Manifold Absolute Pressure (MAP) Sensor
    • Fuel Injectors
    • ETC ( Electronic Throttle Control )
  6. Install ignition wires.
  7. Connect Brake booster hose, purge hose, and MUA hose ( Make Up Air hose ).
  8. Install air inlet hose.
  9. Connect negative cable to battery.
  10. Install engine cover.
scientia non olet · About LEMON Manuals