LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (HVAC System (Service Information)) >> Controls >> Sensor - Ambient Air Temperature >> Installation

Sensor - Ambient Air Temperature: Installation

WARNING: This page is about a different car, the 2005 Dodge Magnum and 2005 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sensor - Ambient Air Temperature
GC0013936Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the ambient air temperature sensor (2) onto the bottom of the front bumper beam (4).
  2. Install the push pin (3) that secures the ambient air temperature sensor to the front bumper beam.
  3. Connect the wire harness connector (1) to the ambient air temperature sensor.
  4. Install the front end splash shields (Refer to SHIELD-WHEELHOUSE - FRONT ).
  5. Lower the vehicle.
  6. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals