LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 393 (HVAC Systems (Service Information)) >> Controls - Front >> Control-A/C Heater >> Removal

Control-A/C Heater: Removal

WARNING: This page is about a different car, the 2005 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
Fig 1: Removing/Installing Center Bezel With A/C Heater Control
GC0011009Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the center bezel (1) from the instrument panel, disconnect the wire harness connector(s) (2) from the A/C-heater control (3) and place the center bezel on a workbench (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - REMOVAL) .
    Fig 2: Removing/Installing A/C Heater Control To Center Bezel
    GC0011010Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the four screws (1) that secure the A/C-heater control (2) to the instrument panel center bezel (3).
  4. Remove the A/C-heater control from the instrument panel center bezel.
scientia non olet · About LEMON Manuals