LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 574 (Electronic Control Modules (Service Information)) >> Module-Memory Seat >> Installation

Module-Memory Seat: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The Memory Seat Module (MSM) mounting tabs can be damaged during module installation. Use care to properly align tabs to prevent binding that could result in tab breakage.
Fig 1: Removing/Installing Module
GC0027622Courtesy of DAIMLERCHRYSLER CORP.
  1. Place the module (4) into position making sure the mounting tabs are properly aligned with the front bracket.
  2. Push down on the rear of the module (4) snapping the retaining clips into place in the side brackets.
  3. Connect the MSM rear harness connectors (1).
  4. Connect the MSM front harness connectors.
  5. Install the driver seat cushion/cover (2) (Refer to BODY/SEATS/SEAT CUSHION COVER - INSTALLATION) .
  6. Connect the battery negative cable.
  7. Verify system and vehicle operation.
scientia non olet · About LEMON Manuals