PDC B(+) Terminal Module
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
INSTALLATION
- From the bottom of the PDC housing, align and insert the B(+) terminal module into the PDC.
- From the bottom of the PDC housing, align and insert the two studs of the PDC B(+) terminal module through the bus bar in the PDC.
- From the bottom of the PDC housing, press the B(+) terminal module gently and evenly into the PDC until both of the latches are fully engaged.
- Install the PDC housing lower cover.