LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Liberty Renegade, 4WD, Part Time, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear >> Lower Control Arm >> Installation

Lower Control Arm: Installation

  1. Position the lower suspension arm in the axle bracket and frame rail bracket.
    NOTE: The end of the arm with the voided round bushing attaches to the axle bracket.
  2. Install the axle bracket bolt and nut finger tight. See Figure.
    NOTE: When installing the right side suspension arm to the frame rail it will be necessary to pry the exhaust over slightly to allow enough clearance to install the bolt.
  3. Install the frame rail bracket bolt and nut finger tight.
  4. Install the stabilizer bar retaining bolts to the suspension arm.
  5. Remove the supports and lower the vehicle.
  6. With the vehicle on the ground tighten the nut at the frame to 163 N.m (120 ft. lbs.). Tighten the nut at the axle bracket to 163 N.m (120 ft. lbs.).
scientia non olet · About LEMON Manuals