LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Liberty Renegade, 4WD, Part Time, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Knuckle >> Installation

Suspension System: Front: Knuckle: Installation

  1. Install the knuckle to the vehicle.
  2. Install the upper ball joint nut. Tighten the nut to 81 N.m (60 ft.lbs.).
  3. Install the lower ball joint nut. Tighten the nut to 81 N.m (60 ft.lbs.).
  4. Install the outer tie rod end to the steering knuckle. (Refer to STEERING/LINKAGE/TIE ROD END - INSTALLATION) .
  5. Install the hub/bearing. (Refer to SUSPENSION/FRONT/HUB / BEARING - INSTALLATION) .
  6. Install the axle shaft nut. Tighten the nut to 135 N.m (96 ft.lbs.). (if equipped with four wheel drive).
  7. Install the wheel speed sensor. (Refer to BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - INSTALLATION) .
  8. Install the disc brake rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .
  9. Install the caliper adapter. (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPER ADAPTER - INSTALLATION) .
  10. Install the tire and wheel assembly. (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  11. Perform the set toe procedure (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals