3.7L V-6

Fig 1: Identifying Throttle Cable Release Tab - 3.7L V-6

Courtesy of DAIMLERCHRYSLER CORP.

Slide accelerator cable plastic mount into throttle body mounting bracket. Continue sliding until release tab (2) is aligned to hole in mounting bracket.

Fig 2: Identifying Slide Throttle Cable Pin - 3.7L V-6
Courtesy of DAIMLERCHRYSLER CORP.
Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) into throttle body bellcrank.

Fig 3: Removal & Installation Of Throttle Control Cable
Courtesy of DAIMLERCHRYSLER CORP.
Push rubber grommet (3) through opening in dash panel.
From inside vehicle, slide throttle cable core wire into opening (slot) in top of pedal arm.
Push plastic cable retainer (clip) (2) into pedal arm opening until it snaps in place.
Install air resonator tube to throttle body.
Before starting engine, operate accelerator pedal to check for any binding.