Front Mount: Removal

WARNING: This page is about a different car, the 2003 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

The front mounts support the engine at each side. These supports are made of resilient rubber.

Disconnect negative cable from battery.
Raise the vehicle.
Support the engine.
Remove the nut from the through bolt (Fig 1) (Fig 2). DO NOT remove the through bolt.

Fig 1: Removing Nut From Through Bolt - Left Front Engine Mount
Courtesy of DAIMLERCHRYSLER CORP.

Fig 2: Removing Nut From Through Bolt - Right Front Engine Mount
Courtesy of DAIMLERCHRYSLER CORP.
Remove the retaining bolts and nuts from the insulator.
Remove the through bolt.
Remove the insulator.