LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Liberty Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Interior) >> Floor Console >> Installation

Floor Console: Installation

WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY OPERATION REQUIRING THE KEY TO BE TURNED "ON", WHILE WORKING IN THE CONSOLE AREA. E.G. CONSOLE, CARPET, OR SEAT REMOVAL OR INSTALLATION; SHIFTER LINKAGE ADJUSTMENT OR REPLACEMENT; PARKING BRAKE CABLE REPLACEMENT OR ADJUSTMENT. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Position console in vehicle. Ensure rear passenger HEVAC duct is engaged.
  2. Install screws attaching rear of console to floor.
  3. Position rear bin in console.
  4. Install screws attaching rear bin to console.
  5. Install screws attaching front of console to floor and place front bin mat in front bin.
  6. Return transmission shift lever and transfer case lever to original position.
  7. Release park brake.
scientia non olet · About LEMON Manuals