Vehicle Theft Security System: Siren: Installation

Position the alarm siren module onto the front extension of the right front wheel house panel.
Install and tighten the screws that secure the alarm siren module to the front extension of the right front wheel house panel. Tighten the screws to 6 N.m (50 in. lbs.).
Reconnect the wire harness connector for the alarm siren module.
Reconnect the battery negative cable.

NOTE: If the alarm siren module has been replaced with a new unit, the new unit MUST be configured in the Intrusion Transceiver Module (ITM) before the Vehicle Theft Security System can operate as designed. The use of a DRBIII(R) scan tool is required to configure the alarm siren module settings in the ITM.