Ignition Keys To The Skim

WARNING: This page is about a different car, the 2002 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the ON position (transmission in Park/Neutral).
Using the DRBIII(R) and select THEFT ALARM, SKIM then MISCELLANEOUS.
Select PROGRAM IGNITION KEYS.
Enter secured access mode by entering the vehicle 4 digit PIN.
Obtain ignition keys to be programmed from the customer (8 keys maximum).
Using the DRBIII(R), erase all ignition keys by selecting MISCELLANEOUS, and ERASE ALL CURRENT IGN. KEYS.
Program all of the ignition keys. If ignition key programming is unsuccessful, the DRBIII(R) will display one of the following messages:

Programming Not Attempted

The DRBIII(R) attempts to read the programmed key status and there are no keys programmed into the SKIM memory.

Programming Key Failed

Skim is unable to program an ignition key transponder due to one of the following: the ignition key transponder is faulty or the key has been programmed to another vehicle.

8 Keys Already Learned, Programming Not Done

The SKIM transponder ID memory is full.

Learned Key In Ignition

The ID for the ignition key transponder currently in the ignition lock cylinder is already programmed in SKIM memory.