Installation - Rear
CAUTION:
DO NOT allow the waterdam or adhesive to become contaminated with dirt or other foreign substances.
CAUTION:
DO NOT damage the waterdam during removal or installation.
CAUTION:
If the waterdam becomes contaminated or damaged, replace the waterdam.
- Position the actuator rods through the holes in the waterdam.
- Place the waterdam onto the door and pressurize at the butyl bead to seal completely, starting with the top rear locating indent followed by the remaining portion or the waterdam.
- Run hard plastic squeegee firmly around the perimeter of the waterdam making sure that the drain holes at the bottom of the inner door panel are fully covered by the waterdam.
- Install door speaker.