LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Crossover Pipe >> Installation

Crossover Pipe: Installation

WARNING: IF TORCHES ARE USED WHEN WORKING ON THE EXHAUST SYSTEM, DO NOT ALLOW THE FLAME NEAR THE FUEL LINES.
WARNING: THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER WORK AROUND OR ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.
  1. Install the crossover pipe into the hanger insulator.
  2. Install and torque the fasteners in the crossover pipe to the left and right catalytic converter connection.
  3. Install and torque the retaining fasteners holding the crossover pipe to exhaust pipe.
  4. Lower vehicle.
  5. Start the vehicle and inspect for exhaust leaks. Repair exhaust leaks as necessary.
  6. Check the exhaust system for contact with the body panels. Make necessary adjustments, if necessary.
scientia non olet · About LEMON Manuals