LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Liberty Limited, 4WD, Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Power Distribution Center >> Assembly >> Power Distribution Center Assembly >> PDC Lower Cover >> Installation

PDC Lower Cover: Installation

  1. Align the PDC housing lower cover on the bottom of the PDC.
  2. Evenly press the lower cover into place until latches are fully engaged.
  3. Where the headlamp and dash harness enters the PDC, tape the harness securely to the trough formation on the PDC lower cover.
  4. Install the PDC in its mounting location on the battery support.
  5. Install the battery wire harness over the two PDC B+ terminal studs. Torque the nuts to 11.3 N.m (100 in. lbs.).
  6. Install the battery. Refer to BATTERY SYSTEM .
  7. Install the PDC cover.
scientia non olet · About LEMON Manuals