LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Wrangler X, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Accessory Switch Bezel >> Installation

Accessory Switch Bezel: Installation

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Position the accessory switch bezel to the instrument panel.
  2. Reconnect the instrument panel wire harness connectors to the connector receptacles for the accessory switches and the cigar lighter/power outlet on the back of the accessory switch bezel.
  3. Position the accessory switch bezel onto the instrument panel.
  4. Install and tighten the four screws that secure the accessory switch bezel to the instrument panel. Tighten the screws to 2 N.m (20 in. lbs.).
  5. Reinstall the center bezel onto the instrument panel. (Refer to CENTER BEZEL - INSTALLATION  ).
  6. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals