LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Wrangler SE, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Fuel Pump Module Lock Nut 55 (74)
Fuel Rail Bolts (2.4L) 21 (28)
Fuel Tank Mounting Strap Bolts (1)
Fuel Tank Skid Plate 12 (16)
Heated Oxygen Sensor 22 (30)
Ignition Coil Rail Mounting Bolts (4.0L) 21 (29)
Intake Air Temperature Sensor 21 (28)
Intake Manifold Mounting Bolts ( 2.4L) 21 (28)
Oil Pump Drive Hold-Down Bolt (4.0L) 17 (23)
Park/Neutral Switch 25 (34)
Power Steering Pressure Switch (2.4L) 10-16 (14-22)
Spark Plug
2.4L (2) 11 (15)
4.0L 22 (30)
INCH Lbs. (N.m) 
Accelerator Pedal Bracket Nut 75 (8.5)
Camshaft Position Sensor Bolts (4.0L) 18 (2.0)
Crankshaft Position Sensor Bolts/Nuts
One-Bolt Mounting 62 (7.0)
2-Bolt Or Nut Mounting 106 (12.0)
Engine Coolant Temperature Sensor 97 (11.0)
Fuel Rail Bolts/Nuts (4.0L) 75-125 (8-14)
Idle Air Control Motor Screws 62 (7.0)
Ignition Coil Mounting Bolts (2.4L) 97 (11.0)
Leak Detection Pump Mounting Bolts 11 (1.2)
Manifold Absolute Pressure Sensor 26 (2.9)
PCM Mounting Bolts 35 (3.9)
Throttle Body Bolts 97 (11.0)
TPS Bolt 62 (7.0)
TRS Manual Shaft Retaining Screw 45 (5.1)
Vehicle Speed Sensor Bolt 20 (2.2)
(1) Tighten tank strap nuts until length of strap bolt between end of strap bolt and bottom of nut is 1.0-1.3" (28-32 mm). Do not overtighten nuts.
(2) Torque critical tapered design. Do not exceed 15 ft. lbs. torque.