Control Module: Installation
- Check glass assembly position. Adjust to full closed position. Insert pin into holes in lift arm assembly to check position (Fig 1
).
Courtesy of DAIMLERCHRYSLER CORP.
- Set new electronic module in position on top side of motor mounting bracket engaging drive cables with pinion gear in electronics module.
- Install one screw to attach electronics module to motor bracket. Tighten screw to 3 N.m (27 in. lbs.) torque.
- Install motor assembly to motor bracket and electronics module with three screws. Tighten screw to 1.75 N.m (15.5 in. lbs.) torque.
- Remove the new module's timing pin and discard. (Fig 2
)
- Connect electrical connector to module assembly wire harness. Secure any loose wires.
Courtesy of DAIMLERCHRYSLER CORP.
- Install module assembly. (Refer to INSTALLATION
)
- Test operation, adjust as necessary. (Refer to ADJUSTMENTS
)
- Install opening trim lace. (Refer to INSTALLATION
)