LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Liberty Limited, 4WD, Part Time, 45RFE >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Electronic Control Modules) >> Junction Block >> Removal

Junction Block: Removal

WARNING: This page is about a different car, the 2004 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the left end cap from the instrument panel.
  3. Unsnap and remove the left outboard trim bezel from the instrument panel. Located just to the left of the steering column.
  4. Remove the steering column opening cover. See STEERING COLUMN article.
  5. Remove the left cowl trim panel from the vehicle.
  6. Remove the courtesy lamp from under the left side of the instrument panel. This will allow sufficient room to remove the junction block from under the instrument panel.
  7. Working through the steering column opening cover, remove the three bulkhead and two body controller electrical connectors from the junction block assembly.
  8. Detach instrument panel wire harness from the lower channel on the instrument panel. This will allow sufficient room to remove the junction block from under the instrument panel.
  9. Remove the four junction block retaining screws and remove the junction block from under the instrument panel.
scientia non olet · About LEMON Manuals