LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler X, Standard >> Repair and Diagnosis >> Suspension >> Front Suspension >> Removal & Installation >> Spring >> Installation

Removal & Installation: Spring: Installation

  1. Install jounce bumper into mount.
    2. NOTE: Rotation of the spring and prying down slightly on the axle will aid in installation.
  2. Install the spring isolator.
  3. Position the coil spring on the axle pad. It may be necessary to rotate the spring while installing.
  4. Raise the axle into position until the spring seats in the upper mount. Install the spring retainer clip and bolt and tighten to specification. See TORQUE SPECIFICATIONS  .
  5. Install the shock at the axle. See SHOCK  .
  6. Install the ABS wire mounting brackets at the axle (if equipped).
  7. Install the track bar to the axle bracket. See TRACK BAR  .
  8. Install the lower suspension arms to the frame. Install mounting bolts and nuts finger tight. See LOWER CONTROL ARM  .
  9. Install the drag link to the right side knuckle. See KNUCKLE  .
  10. Remove the hydraulic jack from under the axle.
  11. Install the wheel and tire assemblies.
  12. Remove the supports and lower the vehicle.
  13. Tighten the lower suspension arms nuts to specification at normal height with the vehicle weight. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals