LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler SE, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System & Starting System >> Starter Motor >> Installation >> 4.0L Engine

4.0L Engine

  1. Position starter motor to transmission housing.
  2. Connect solenoid terminal wire harness connector to connector receptacle on the starter solenoid. Always support starter motor during this process. Do not let starter motor hang from the wire harness.
  3. Install battery positive cable eyelet terminal onto starter solenoid B(+) terminal stud.
  4. Install and tighten nut securing battery positive cable eyelet terminal to starter solenoid B(+) terminal stud. Tighten nut to 11.3 N.m (100 in. lbs.).
  5. Position starter motor to transmission housing. Loosely install two mounting bolts.
  6. Tighten lower (forward facing) mounting bolt to 40.7 N.m (30 ft. lbs.).
  7. Tighten upper (rearward facing) to 47.5 N.m (35 ft. lbs.).
  8. Lower vehicle.
  9. Connect battery cable.
scientia non olet · About LEMON Manuals