LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Transmission >> NV231 Transfer Case (Service Information) >> Shift Lever >> Installation

Shift Lever: Installation

  1. If shift rod was not removed from lever assembly, work rod down through floorpan opening. Then position lever assembly on floorpan and install assembly attaching screws.
  2. Install console. See CENTER CONSOLE .
  3. Raise vehicle.
  4. Connect trunnion to torque shaft arm. Or, slide shift rod into trunnion on range lever. Be sure shift rod slides freely in trunnion.
  5. Verify that range lever is in 4L position. Then tighten trunnion lock bolt.
  6. Lower vehicle and check transfer case shift operation.
scientia non olet · About LEMON Manuals