LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - 30RH Automatic Transmission >> Gearshift Cable >> Installation

Gearshift Cable: Installation

  1. Route cable through hole in dash panel. Fully seat cable grommet into dash panel.
  2. Place the auto transmission manual shift control lever in "PARK" detent (rearmost) position and rotate prop shaft to ensure transmission is in PARK.
  3. Connect shift cable to shifter mechanism by snapping cable retaining ears into shifter bracket and press cable end fitting onto lever ball stud.
  4. Place the floor shifter lever in PARK position. Ensure that the pawl is seated within the confines of the adjustment gauge clip.
  5. Snap the cable into the transmission bracket so the retaining ears are engaged and connect cable end fitting onto the manual control lever ball stud.
  6. Lock shift cable into position by pushing upward on the adjusting lock button.
  7. Remove and discard the shift cable adjustment gauge clip from the park gate of the shifter.
  8. Install any floor console components removed previously. See CENTER CONSOLE .
scientia non olet · About LEMON Manuals