LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2001 >> Grand Cherokee Laredo, 4.0 S, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Instrument Cluster >> Check Gauges Indicator Inoperative

Check Gauges Indicator Inoperative

NOTE: Check gauges indicator is activated by engine temperature, battery voltage or low oil pressure.
  1. Inspect engine temperature, battery voltage or low oil pressure. Repair as needed. Using scan tool, read ENGINE DTCs. If there are any PCM DTCs present, repair as necessary. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS. If no PCM DTCs are present, go to next step.
  2. Turn ignition switch OFF, then to RUN position. If CHECK GAUGES indicator light illuminates for about 4 seconds and then goes out, test is complete. If CHECK GAUGES indicator light does not illuminate for about 4 seconds and then go out, go to next step.
  3. Remove and inspect CHECK GAUGES bulb. Replace as needed. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS. If bulb is okay, go to next step.
  4. Replace instrument cluster printed circuit board. See appropriate INSTRUMENT PANELS article. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals