Both Mirrors Inoperative
- Check operation of driver's power lock switch. If all doors lock and unlock, replace Driver Door Module (DDM). If door locks are inoperative, check operation of passenger's power lock switch. If door locks are inoperative, go to next step. If all doors lock and unlock, replace DDM. See DRIVER/PASSENGER DOOR MODULE (DDM/PDM) under REMOVAL & INSTALLATION.
- Check fuse No. 12 (50-amp) in Power Distribution Center (PDC). See Fig 1. If fuse is okay, go to next step. If fuse is blown, repair short circuit and replace fuse.
- Check for battery voltage at fuse No. 12 in PDC. If battery exists, go to next step. If battery voltage does not exist, repair open circuit to battery. See appropriate wiring diagram in
POWER DISTRIBUTION article in WIRING DIAGRAMS.
- Disconnect negative battery cable. Remove driver's door trim panel. See FRONT DOOR TRIM PANEL under REMOVAL & INSTALLATION. Disconnect DDM connector C1. See Fig 2. Check for continuity between ground and DDM connector C1 terminal No. 4 (Black wire). If continuity exists, go to next step. If continuity does not exist, repair open in Black wire.
- Reconnect negative battery cable. Check for battery voltage at DDM connector C1 terminal No. 1 (Tan/Light Blue wire). If battery voltage does not exist, repair open in Tan/Black wire or circuit between DDM and PDC. If battery voltage exists, replace DDM. See DRIVER/PASSENGER DOOR MODULE (DDM/PDM) under REMOVAL & INSTALLATION.
Courtesy of CHRYSLER CORP.
Courtesy of CHRYSLER CORP.