LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Grand Cherokee Laredo, 4.0 S, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Power Window >> Driver's Rear Window Inoperative From Rear Switch

Driver's Rear Window Inoperative From Rear Switch

NOTE: Ensure window lockout switch on DDM (driver's front door switch) is operating properly before proceeding.
  1. Remove driver's rear door trim panel. Disconnect driver's rear window switch connector. Using DVOM, measure resistance between ground and driver's rear window switch connector terminal No. 6 (Black wire). See Figure. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, repair open in Black wire. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  2. Remove driver's rear window switch. Using DVOM, measure resistance between specified terminals. See DRIVER'S REAR POWER WINDOW SWITCH CONTINUITY . If resistance is as specified, test is complete. If continuity is not as specified, replace driver's rear window switch. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals