Transmission Range Sensor: Installation
- Disconnect shift control rod from transmission shift lever. Rotate transmission shift lever fully rearward, then forward 2 detent positions to Neutral position.
- Install TR sensor on manual valve shaft. Install adjusting bolt. DO NOT tighten adjusting bolt at this time.
- Install lock washer and retaining nut. Tighten retaining nut to specification. See TORQUE SPECIFICATIONS
. DO NOT bend over lock washer tabs at this time.
- Ensure transmission is in Neutral. Rotate TR sensor to align neutral standard line with vertical groove on manual valve shaft. See Fig 1
.
- Tighten adjusting bolt to specification. See TORQUE SPECIFICATIONS
. Bend lock washer tabs over. Reconnect shift control rod and harness connector. Ensure vehicle starts in Park and Neutral only.
Courtesy of CHRYSLER CORP.