LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Cherokee Classic, 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self Diagnostics >> Diagnostic Tests >> DTC P0463: Fuel Level Sending Unit Volts Too High >> Testing

DTC P0463: Fuel Level Sending Unit Volts Too High: Testing

  1. Turn ignition on, with engine off. Using scan tool, read FUEL LEVEL SENSOR voltage. If voltage is more than 9.4 volts, go to next step. If voltage is 9.4 volts or less, go to step  6 .
  2. Turn ignition off. Disconnect fuel pump module connector. Fuel pump module is mounted in top of fuel tank. Inspect connector for damaged pins, corrosion and loose terminals. Repair connector as necessary. If connector is okay, connect a jumper wire between Dark Blue/Light Green wire and Brown/Yellow wire at fuel pump module connector. Turn ignition on, with engine off. Using scan tool, read FUEL LEVEL SENSOR voltage. If voltage is one volt or more, go to next step. If voltage is less than one volt, replace fuel level sensor. Fuel level sensor is located on fuel pump module and can be replaced separately. See FUEL LEVEL SENSOR under FUEL SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION article.
  3. Turn ignition off. Disconnect jumper wire. Reconnect jumper wire between ground and Dark Blue/Light Green wire at fuel pump module connector. Turn ignition on, with engine off. Using scan tool, read FUEL LEVEL SENSOR voltage. If voltage is one volt or more, go to next step. If voltage is less than one volt, repair open in Brown/Yellow wire between fuel pump module connector and PCM.
  4. Turn ignition off. Disconnect PCM connectors. PCM is located in engine compartment on left front fender, near radiator support. Inspect connectors for damaged pins, corrosion and loose terminals. Repair connectors as necessary. If connectors are okay, measure resistance of Dark Blue/Light Green wire between fuel pump module connector and terminal No. 26 at PCM C3. See Figure . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Dark Blue/Light Green wire between fuel pump module and PCM.
  5. At this time, PCM is assumed to be defective. Replace PCM.
  6. Ensure ignition is still on, with engine off. Using scan tool, monitor FUEL LEVEL SENSOR voltage while wiggling fuel pump module connector and wiring harness. Fuel pump module is mounted in top of fuel tank. If voltage changes while wiggling wiring harness, repair wiring harness where wiggling caused voltage to change. If voltage does not change while wiggling wiring harness, go to next step.
  7. Visually inspect related connectors and wiring harness for damage. Repair connectors and wiring harness as necessary. If connectors and wiring harness are okay, no problem is indicated at this time. Rest is complete.
scientia non olet · About LEMON Manuals