LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1999 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> No-Start Tests >> Test NS-SEL: No Start Selection Menu

Test NS-SEL: No Start Selection Menu

  1. If PCM has not been replaced, go to next step. If PCM has been replaced, correct VIN and mileage must be reprogrammed. Using scan tool, enter correct VIN and mileage into PCM. Erase codes in ABS and air bag modules. Go to next step.
  2. If vehicle is not equipped with Smart Key Immobilizer Module (SKIM), go to step 4). If vehicle is equipped with SKIM, secret key data must be updated to enable starting. Go to next step.
  3. Using scan tool, select ENGINE MISC and then SKIM. Select SECURED ACCESS MODE and enter appropriate PIN code for this vehicle. Select UPDATE SECRET CODE data. Data will be transferred from SKIM to PCM. Go to next step.
  4. Ensure battery is fully charged. Attempt to crank engine. If engine will not crank, perform TEST NS-9A: REPAIRING NO CRANK CONDITION  . If engine cranks, but does not start and scan tool displays NO RESPONSE, perform TEST NS-6A: REPAIRING NO RESPONSE CONDITION  . If engine starts and scan tool displays NO RESPONSE, perform TEST NS-6C: REPAIRING NO RESPONSE CONDITION  . If engine starts and scan tool does not display NO RESPONSE, go to next step.
  5. Turn ignition off. Turn ignition on, but do not crank engine. Using scan tool, read DTCs. If any DTCs are displayed, perform appropriate test for specified DTC(s) proceed to appropriate DTC test. See DTC MESSAGES & CODES table. If no DTCs are displayed, perform TEST NS -1A: QUALIFYING NO START CONDITION
scientia non olet · About LEMON Manuals