LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1999 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Communication System >> System Tests >> No Response From Remote Keyless Entry (RKE)

No Response From Remote Keyless Entry (RKE)

  1. Disconnect transmission control module. Disconnect RKE module connector. Connect jumper wire between ground and terminal No. 12 (White/Black wire). Turn ignition on. Using scan tool, select BODY, BODY COMPUTER, then SYSTEM TEST. Perform CCD BUS test. If scan tool displays BUS SHORTED TO GROUND, go to next step. If scan tool displays BUS SHORTED TO GROUND, repair open White/Black wire.
  2. Ensure ignition is on. Using voltmeter, measure voltage between ground and terminal No. 2 (Pink wire) on RKE module harness connector. If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, repair open Pink wire.
  3. Using voltmeter, measure voltage between ground and terminal No. 8 (Pink wire) on RKE module harness connector. If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, repair open Pink wire.
  4. Connect jumper wire between ground and terminal No. 6 (Violet/Brown wire). Using scan tool, perform BUS TEST. If scan tool displays BUS SHORTED TO GROUND, replace RKE module. If scan tool displays BUS SHORTED TO GROUND, repair open Violet/Brown wire.
scientia non olet · About LEMON Manuals