Memory Seat Test 3A - Seat Belt Status Not Received
NOTE:
Perform MEMORY SEAT TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Refer to SEATS - POWER
article. After each repair, perform Perform TEST VER-3A
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Using scan tool, read BCM S-BELT status. If scan tool displays BCM S-BELT STATUS: NO RESP, replace Body Control Module (BCM). BCM is located under left side of dash. See Figure in CHIME TEST 3A. If scan tool does not display BCM S-BELT STATUS: NO RESP, go to next step.
- Using scan tool, read BCM S-BELT status. If scan tool displays SEAT BELT STATUS MESSAGE NOT RCVD, replace memory seat module. If scan tool does not display SEAT BELT STATUS MESSAGE NOT RCVD, replace BCM.