LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1998 >> Grand Cherokee 5.9 Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> System Testing >> Interior Lighting Test 4A - Courtesy Lights Inoperative From Liftgate

Interior Lighting Test 4A - Courtesy Lights Inoperative From Liftgate

NOTE: Perform INTERIOR LIGHTING TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
  1. Close all doors. Open liftgate. Using scan tool, check status of liftgate ajar switch. If scan tool does not display LIFTGATE AJAR SWITCH: CLOSED, go to DOOR AJAR TEST 9A  . If scan tool displays LIFTGATE AJAR SWITCH: CLOSED, go to next step.
  2. Disconnect liftgate (cargo) courtesy light connector. If front courtesy lights illuminate, replace liftgate courtesy light assembly. If front courtesy lights do not illuminate, go to next step.
  3. Disconnect Body Control Module (BCM) Black 14-pin connector. BCM is located under left side of dash. See Figure in CHIME TEST 3A. Using scan tool in voltmeter mode, measure voltage at terminal "C" (White/Light Green wire) on liftgate (cargo) light connector. If voltage is more than one volt, repair short in White/Light Green wire. If voltage is one volt or less, replace BCM.
scientia non olet · About LEMON Manuals