LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1998 >> Cherokee Classic, 2.5 P >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (4.0L Engine) >> Removal & Installation >> Intake Manifold >> Installation

Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Ensure all gasket surfaces are clean. Install NEW gasket. Install exhaust manifold and tighten bolt No. 3 finger tight. Install intake manifold and remaining bolts loosely. Replace fuel line quick-connect "O" rings, spacers and retainers.
  2. Tighten bolts in proper sequence to specification. See Fig 1. See TORQUE SPECIFICATIONS  table. Reverse removal procedure to complete installation.
Fig 1: Manifold Tightening Sequence
G91E14302Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals