LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1997 >> Wrangler SE, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L >> Verification Tests >> Test VER-3A - Charging Verification

Test VER-3A - Charging Verification

  1. Inspect vehicle to ensure all engine components are connected. Re-assemble and reconnect components as necessary. If Powertrain Control Module (PCM) has been changed, go to next step. If PCM has not been changed, go to step 3).
  2. Connect scan tool to Data Link Connector (DLC). If vehicle is not equipped with factory Vehicle Theft Security System (VTSS), go to next step. If vehicle is equipped with VTSS, start vehicle at least 20 times so VTSS can be activated when desired. Using scan tool, erase DTCs and go to next step.
  3. To ensure no charging system problems exist, start engine. Increase engine speed to 2000 RPM for at least 30 seconds. Allow engine to idle. Turn engine off and go to next step.
  4. Turn ignition on. Using scan tool, read DTCs. If repaired DTC has reset, repair is not complete. Check for related Technical Service Bulletins (TSBs) and return to DTC TEST, if necessary. If another DTC exists, return to DTC TEST and follow procedure specified by other DTC. If no other DTCs exist, repair is now complete.
scientia non olet · About LEMON Manuals